The X-stream™ is placed into the load just prior to dropping your shot charge. Then, once the shot is dropped, the pellets fall into one of the four sectioned chambers with a few layers covering the top. The layer on top will fill the center-section of your pattern, while the pellets below, in the chambers, will be evenly dispersed toward the outside pattern. The results are more consistent patterns, wider patterns (by about one choke spec.) and fewer deformed, fly-away pellets. The X-Stream does not require a special rammer tube or special tools.

Gas Seals for 10g, 12g & 20g
Pack of 250 pieces

12g & 20g
Cylindric pillar center for central projectile support. Symmetrical straight-edge Obturator gas seals for the 12 & 20 gauge loader. Excellent for slug loads and high speed loading machinery.

10g
The X10X is symmetrical (can be flipped) for easy loading. It provides numerous practical loading applications. Though the wads expand for overbores, the fit is still perfect with standard-dimension bores. Manufacturers enjoy its easy high-speed loading and versatility even in slug-shooting and high-performance loads. Useful for big-bore Pagoda loads.

Years ago, Ballistic Products developed this special combination of ingredients to handle the difficulties of steel and very large pellets. As an absolute success, Mix 47 has been used for all buffering applications since. Minimum pressure increase, maximum pattern density, and round pellets are the result with Mix 47. Mix 47 stabilizes steel shot pellets and keeps patterns dense, even under the stress of 1500 fps velocities!

Gas Checks for Cast Projectiles.
Pack of 1000 pieces
Calibre Range -
22, 25, 270, 30, 32/8mm, 338, 348, 35, 375, 416, 44, 45, 475, 50, 6mm, 6.5mm.

Priced from $95.00 as reflected in your cart.